Applications
Clear sand at the bottom of water tank of water jet cutter. The recirculated high pressure water formed by the equipment itself strikes the sand in the water tank to form the mixture of water and sand, then, the mixture will be sucked into the equipment, and the sand of water jet cutter will sink to the bottom of the equipment, while the rest of the water flows back to water tank after passing through the automatic water sand separation system.
Type and Parameters
|
Type
Parameters
|
CS-046
|
CS-061
|
|
Equipment diameter
|
∮630mm
|
∮720mm
|
|
Capacity
|
460L
|
610L
|
|
Weight
|
460kg
|
530kg
|
|
Height
|
2.1m
|
|
Diaphragm Flow
|
20.4m3/h
|
|
Desanding speed
|
0.5m3/h
|
III. Product characteristics
The characteristics of the water cutting desanding system of WAMIT:
1) The normal operation of water jet cutter cannot be affected by desanding.
The desanding equipment can put the suction cutter into the water tank of water jet cutter to remove sand when the water jet cutter is operating. The normal operation of water jet cutter cannot be affected during desanding. The equipment is completely free from the inconvenience of traditional desanding that the water in water tank must be drained, and then water tank shall be filled again after sand removing, which wins precious time for normal work.
2) Simple operation, thorough sand removal and fast speed.
The equipment only takes five steps to complete sand removal: 1. Put the equipment in place→ 2. Connect the air supply→ 3. Put sand suction nozzle into the water tank→ 4. Turn on the air switch to remove sand→ 5. Pour out waste sand after the device stops with full sand. Its desanding efficiency is more than 90%. In the case that there is much sand and little mud and other impurities (plastic paper, nylon net, gravel, etc.) in the water tank, it only takes about 60 minutes to remove all sand in the tank.
3) High capacity.
The diameter of the equipment is 630 (720) mm; and its height can reach up to 2.1 M. It can remove 460(610)litres of sand a time. The water tank of 2 x3m, for example, can continue to be used after removing 3-4 cans of sand.
4) Thick steel plate and perfect hydraulic system.
The tank of the equipment adopts steel pipe of 8mm, integrating advanced water sand separation system inside the tank. The base is made of steel plate of 20mm which is durable. Manual hydraulic system is adopted to open and close the tank door with safety bolt, making the open and closing and sealing of door simple, safe and convenient.
5) Forceful and stable power.
The equipment adopts the most advanced international pneumatic diaphragm pump; under the drive of high pressure air, it can produce a steady water flow with high pressure to provide power for removing sand quickly.
6) Environment protection and energy saving.
The equipment, in the whole process of desanding, does not consume water in water tank; therefore, it doesn’t cause the waste of water resources.
Note: ① Air source requires an air pipe with the diameter of 12 mm with air pressure of 0.2 - 0.6MPa, and air demand exceeding 0.6 m³/minute.
② Before desanding, the desanding system shall be filled with fresh water.
